Honda Civic Fog Light Harness Installation
1. Ensure you have the anti-theft codes for the audio system and navigation system (if outfitted), then write down the radio presets.
2. Disconnect the destructive cable from the battery.
3. Remove the front bulkhead cowl (two expansion clips, three clips, and transfer the appropriate and left fender trims inward).
4. With the help of an assistant, remove the entrance bumper (four long clips, 4 middle clips, two socket bolts, and two self-tapping screws). To forestall damage, set the entrance bumper on a blanket.
5. Take away the left fog light cowl (4 pawls).
6. Set up the spring nut onto the entrance bumper.
7. Set up the left fog light to the fog light cover opening, and secure it with the self-tapping screw.
8. Repeat steps 5 by way of 7 on the other side.
9. Route the fog light harness 2-pin connector between the decrease grille and the entrance bumper from the correct aspect by means of the left side.
10. Attach the clip on the fog light harness to each gap of the decrease grille.
11. Safe the fog light harness to the lower grille with one wire tie.
12. Plug the fog light harness 2-pin connector into the left fog light bulb.
13. Plug the light harness 2-pin connector into the best fog light bulb.
14. Install the fog light harness clip onto the decrease grille rib.
15. Take away three bolts from the washer reservoir tank.
16. Locate the 1-pin connector blue-taped to the automobile harness and remove the blue tape to free the 1-pin connector. Plug the car 1-pin connector you simply freed into the sub harness 1-pin connector.
17. Route the sub harness between the washer reservoir tank and automobile panel as shown.
18. Safe the sub harness ground terminal to the vehicle frame utilizing the bottom bolt supplied.
19. Reinstall the washer reservoir tank. Check that the pipe is put in securely.
20. Secure the sub harness clip to the automobile frame, and secure the sub harness to the car harness utilizing two wire ties.
21. Slide the clip onto the sub harness 4-pin connector, and safe it to the automobile frame.
22. Plug the light harness four-pin connector to the sub harness 4-pin connector, then reinstall the front bumper.
23. If equipped, remove the driving force’s dashboard beneath cowl by turning the knob counterclockwise, and releasing two clips and pin. Take care not to harm the clips.
24. Remove the driver’s dashboard lower cover (eight clips). Take care not to harm the clips.
